Adding Static Routes; Figure 7.3 Static Route Configuration - Asus RX3042H User Manual

RX3042H User's Manual
Field Description
Subnet Indicates which parts of the destination address refer to the
Mask network and which parts refer to a computer on the network.
Refer to Appendix 11, for an explanation of network masks.
The default route uses a 0.0.0.0 for subnet mask.
Gateway
Gateway IP address
Interface Available option include AUTO, Eth0 (LAN), Eth1 (WAN),
PPPoE:0 (unnumbered), PPPoE:1 (1st PPPoE session),
PPPoE:2 (2nd PPPoE session). These options are
selectable from the drop-down list. If AUTO is selected, the
router will automatically assign an interface to route the
packets based on the gateway IP address.

7.3.2 Adding Static Routes

Figure 7.3. Static Route Configuration
Follow these instructions to add a static route to the routing table.
1. Open the Static Route configuration page by clicking the
Advanced ->Static Route menu.
2. Enter static routes information such as destination IP address,
destination subnet mask, gateway IP address and the interface
in the corresponding fields.
For a description of these fields, refer to Table 7.2. Static
Route Configuration Parameters.
To create a route that defines the default gateway for your
LAN, enter 0.0.0.0 in both the Destination IP Address and
Subnet Mask fields.
3. Click Add to add a new route.
Routing
57