Configuring Pppoe For Wan - Asus RX3042H User Manual

Router Setup
Setting
Connect on
Demand
Status
Manual
Disconnect/
Connect
5.2.2.2 Configuring PPPoE for WAN
Follow the instructions below to configure PPPoE settings:
1. Open the Network Setup configuration page by clicking the
Router Setup -> Connection menu.
2. Select which WAN port (WAN1/WAN2) to configure for PPPoE
connection mode.
3. Select PPPoE from the WAN Connection Mode drop-down list
as shown in Figure 5.3.
4. Select PPPoE session ID from the PPPoE session ID drop-
down list. Currently, two sessions are supported for each WAN
port.
5. Enter the service name if required by your ISP.
6. (Optional) Enter the service name and/or AC name if required by
your ISP.
7. (Optional) If your ISP allows you to always obtain the same IP
address for your WAN, enter it in the IP Address field; otherwise,
skip this step.
8. (Optional) Enter the IP addresses for the primary and/or
secondary DNS servers if you want to use your preferred DNS
servers; otherwise, skip this step.
9. (Optional) Change the MTU value if necessary. If you do
not know what value to enter, leave it as is. For dynamic IP
32
Description
Click on the Enable or Disable radio button to enable
or disable this option.
On: PPPoE connection is active.
Off: No PPPoE connection is active.
Connecting: RX3042H is trying to connect to your
ISP using PPPoE connection mode.
Click the Disconnect or Connect button to disconnect
or connect using the PPPoE connection mode.
RX3042H User's Manual