Pstn- To -Voip Calls; Route Calls To Pstn; Forward Calls To Pstn - Grandstream Networks HT-488 User Manual

PSTN- -VOIP C
TO ALLS
This function is available using the FXO port. The FXO port functions as a bridge between the Internet
and PSTN and enables calls to be passed from the PSTN network to VoIP. The user can make VoIP calls
remotely by dialing into the FXO line port on HT488.
T M PSTN- -V
O AKE A TO O
1. Make an incoming call to the PSTN line on FXO port. The phone will ring for 4 times by default
(this setting is configurable on the configuration page).
2. If no one answers the call after 4 rings (default configuration), then the caller hears either a
special continuous tone (prompting a PIN number) or a dial tone.
3. Enter a valid PIN. The caller will hear dial tone and be bridged to VoIP. If an incorrect PIN is
inputted, the continuous tone prompts caller to enter a valid PIN. The caller may try 3 times to
enter a valid PIN, then the HT488 will hang up.
4. The caller can dial a VoIP number followed by # (or wait for 4 seconds), the VoIP call will be
initiated from the SIP account configured on the FXO port.
Note:
•
Users can choose whether or not to apply password protection for VoIP-to-PSTN calls. A PIN
(Pin for PSTN calls) consists of up to 8 numeric digits and can be configured using the BASIC
SETTINGS of the web configuration page. By default, there is no password protection. (i.e. there
is no authentication required for callers on the use of PSTN line through HT488).
•
When a PIN is configured for VOIP-to-PSTN call flow, the VoIP device that calls into the HT488
FXO account needs to configure RFC2833 or SIP Info for DTMF digit transmission.
•
The special continuous tone is the prompt to enter a valid PIN code. If a caller doesn't enter a
valid PIN, the HT488 times out after 10 seconds. Users may press the "#" key to indicate the end
of an input or wait 4 seconds.
•
On the web configuration page, if the "Forward to VoIP" is configured, the second stage dialing
format is eliminated, so after dialing into the FXO SIP account number, the PSTN number will be
called automatically
R C PSTN
OUTE ALLS TO
The FXO port enables access to the PSTN network. By default, the HT488 is in VoIP mode at off-hook.
If "Route call to PSTN" is configured, certain calls will be initiated from the FXO PSTN line port. This call
feature is especially useful for emergency calls or local telephone calls.
To use this feature, users need to specify a prefix or a telephone number in the "Route call to PSTN" in
the BASIC SETTINGS web configuration page. If the dialed digits match the specified prefix, outbound
calls will be initiated from PSTN line.
For example, if "Route call to PSTN" is configured as 626, all outgoing calls starting with 626 will be
initiated from the PSTN line.
F C PSTN
ORWARD ALLS TO
Any VOIP call may be forwarded to a specified PSTN number if the call is not answered after a pre
configured numbers of rings. By default "Number of Rings" parameter has value 4.
Grandstream Networks, Inc.
IP C :
ALL
HT488 User Manual
Firmware 1.0.3.64
Page 14 of 33
Last Updated: 4/2007