End User Configuration; Figure 3: Screenshot Ofc - Grandstream Networks HT-488 User Manual

From the WAN port:
•
1. Follow table 4 to find the WAN side IP address.
2. Open a web browser, type in the WAN side IP address – for example:
http://HT-488-WAN-IP-Address
Note:
WAN side HTTP access is disabled by default for security reason. You can enable HTTP access
•
on the configuration page by setting "WAN side HTTP access" to be YES.
Initial access to the configuration pages is always from the LAN port. The instructions are listed
•
above.
• The IVR announces 12 digits IP address, you need to strip out the leading "0" in IP address. For
ex. IP address: 192.168.001.014, you need to type in http://192.168.1.14 in the web browser.
E U C
ND SER ONFIGURATION
Once the HTTP request is entered and sent from a web browser, the user will see a log-in screen. There
are two default passwords for the login page:
User Level:
End User Level
Administrator Level
Only an administrator can access the "ADVANCED SETTING" configuration page. Please reference the
GUI pages using the following link:
Once this HTTP request is entered and sent from a Web browser, the HT488 will respond with the
following login screen:
F 3: S
IGURE CREENSHOT OF
The password is case sensitive with maximum length of 25 characters. The factory default password for
End User and administrator is "123" and "admin" respectively. Only an administrator can access the
"ADVANCED SETTING" configuration page.
Grandstream Networks, Inc.
Password:
123
admin
http://www.grandstream.com/user_manuals/GUI/GUI_HT488.rar.
C L - P
ONFIGURATION OG IN
HT488 User Manual
Firmware 1.0.3.64
Web pages allowed:
Only Status and Basic Settings
Browse all pages
AGE
Page 18 of 33
Last Updated: 4/2007