Grandstream Networks HT-488 User Manual page 20

Cloned WAN MAC
Address:
LAN Subnet Mask
LAN DHCP Base IP:
DMZ IP:
Port Forwarding:
Number of rings
PSTN access code
PIN for PSTN calls
PIN for VoIP calls
Route Call to PSTN
Forward to PSTN
Forward to VoIP
Grandstream Networks, Inc.
month,day,weekday,hour,minute
•
• month: 1,2,3,..,12 (for Jan, Feb, .., Dec)
• day: [+|-]1,2,3,..,31
• weekday: 1, 2, 3, .., 7 (for Mon, Tue, .., Sun), or 0 which means the daylight
saving rule is not based on week days but based on the day of the month.
hour: hour (0-23), minute: minute (0-59)
•
If "weekday" is 0, it means the date to start or end daylight saving is at exactly the given
date. In that case, the "day" value must not be negative. If "weekday" is not zero and
"day" is positive, then the daylight saving starts on the first "day" th iteration of the
weekday (e.g.: 1st Sunday, 3rd Tuesday etc).
If "weekday" is not zero and "day" is negative, then the daylight saving starts on the last
"day"th iteration of the weekday (last Sunday, 3rd last Tuesday etc).
The saving is in the unit of minutes. The saving time may also be preceded by a
negative (-) sign if subtraction is desired instead of addition.
The default value is set for US, the "Automatic Daylight Saving Time Rule" shall be set
to "3,2,7,2,0;11,1,7,2,0;60"
Examples
US/Canada where daylight saving time is applicable:
03,02,7,02,00;11,1,7,02,00;60
This means the daylight saving time starts from the second Sunday of March at 2AM
and ends the first Sunday of November at 2AM. The saving is 60 minutes.
Allow the user to set a specific MAC address. Set in Hex format
Sets the LAN subnet mask. Default value is 255.255.255.0
Base IP for the LAN port, which functions as default gateway for its LAN. Default value
is 192.168.2.1
Forward all WAN IP traffic to a specific IP address if no matching port is used by
HandyTone-488 itself or in the defined port forwarding.
Allow users to forward a matching (TCP/UDP) port to a specific LAN IP address with a
specific (TCP/UDP) port.
Default is 4. It specifies number of phone rings before a PSTN incoming call is bridged
to VoIP
The code to access the PSTN line. Default is "*00".
PIN code to bridge from VoIP to PSTN
PIN code to bridge from PSTN to VoIP
If the dialed digits match one of the specified prefix here, outbound calls will be initiated
from PSTN line. This field is especially useful for emergency calls.
Calls are unconditionally forwarded to the specified PSTN phone number for all
incoming VoIP calls on FXO port.
Calls are unconditionally forwarded to the specified VoIP phone number for all
incoming PSTN calls.
HT488 User Manual
Firmware 1.0.3.64
Page 20 of 33
Last Updated: 4/2007