Connecting And Disconnecting An Ipod; Connecting Your Ipod; Disconnecting Your Ipod; Flow From Startup To Termination - Pioneer AVIC-F710BT Operation Manual

Chapter
02 Basic operation
Connecting and
disconnecting an iPod
CAUTION
! To prevent data loss and damage to the sto-
rage device, never remove it from this naviga-
tion system while data is being transferred.
! If data loss or corruption occurs on the sto-
rage device for any reason, it is usually not
possible to recover the data. Pioneer accepts
no liability for damages, costs or expenses
arising from data loss or corruption.

Connecting your iPod

Using the USB interface cable for iPod en-
ables you to connect your iPod to the naviga-
tion system.
p A USB interface cable for iPod (CD-IU230V)
(sold separately) is required for connection.
1 Pull out the USB storage device after
checking that no data is being accessed.
To AV input on the back of the navigation system
USB connector
p For more details about iPod compatibility
with this navigation system, refer to the in-
formation on our website.
p Connection via USB hub is not possible.
2 Connect your iPod.
14
Engb
USB interface cable for
iPod

Disconnecting your iPod

% Pull out the USB interface cable for iPod
after checking that no data is being ac-
cessed.
Flow from startup to
termination
CAUTION
For safety reasons, the rear view camera function
is not available until the navigation system boots
up completely.
1 Start the engine to boot up the system.
After a short pause, the navigation splash
screen comes on for a few seconds.
2 Turn off the vehicle engine to termi-
nate the system.
The navigation system is also turned off.

On first-time startup

When you use the navigation system for the
first time, select the language that you want to
use.
1 Start the engine to boot up the system.
After a short pause, the navigation splash
screen comes on for a few seconds.
2 Touch the language that you want to
use on the screen.