Save As; Setting The Location As A New Destination; Setting The Location As A Waypoint; Replacing The Location As The New Final Destination - Pioneer AVIC-F710BT Operation Manual

Navigation av system
Hide thumbs Also See for AVIC-F710BT:
Table of Contents

Advertisement

Chapter
04
After the location is decided (Map Confirmation Screen)
= For more details of the operation, refer to
Replacing the location as the new final desti-
nation on this page.
Starting Point
Sets the location as a starting point.
= For more details of the operation, refer to
Setting the location as the start point on the
next page.

Save as...

Add Pin
Puts a map pin at the cursor position as a
mark up.
= For details, refer to Placing a map pin on the
location on the next page.
Add POI
Stores the cursor position as a POI.
= For details, refer to Registering the location
as a customised POI on page 38.
Add Favourite
Stores the cursor position as one of the "Fa-
vourites".
= For details, refer to Storing the location in
"Favourites" on page 39.
Add Cam
Stores the cursor position as a safety camera
location.
= For details, refer to Storing the position as a
safety camera location on page 39.
36
Engb
Setting the location as a
new destination
1
Touch [Route...] on the
"Map Confirmation Screen".
2
Touch [Go Here Now].
When the route is not set, route calculation
starts immediately.
When a route has already been set, a message
will appear asking you to cancel it. Touch [Yes]
to start the route calculation.
p When the cursor overlaps with a destina-
tion that has already been set, touch [Re-
move Dest.] to cancel the current route or
recalculate the route by setting one of the
remaining waypoints as the destination.
Setting the location as a
waypoint
1
Touch [Route...] on the
"Map Confirmation Screen".
2
Touch [Add Via].
p When the cursor overlaps a waypoint al-
ready set, touch [Remove Via] to delete the
waypoint and recalculate the route.
Replacing the location as
the new final destination
1
Touch [Route...] on the
"Map Confirmation Screen".
2
Touch [Continue].
p Recalculates the route by setting the cursor
position as the new destination. The pre-
vious destination becomes a waypoint.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avic-f9110btAvic-f910bt

Table of Contents