Switching The Sound Muting/ Attenuation; Setting The Rear Output; Switching Auto Pi Seek - Pioneer AVIC-F710BT Operation Manual

Chapter
21 Customising preferences
Switching the sound muting/
attenuation
You can select the muting method when the
navigation guidance is output. This setting is
also effective for a mute signal that has been
received from the MUTE lead connected to the
navigation system.
p When you use a mobile phone connected
with Bluetooth technology (dialling, talking,
incoming call), the AV source volume is al-
ways muted independently of this setting.
% Touch [MUTE Input/GUIDE] on the "AV
System Settings" menu.
= For details, refer to Displaying the "AV Sys-
tem Settings" menu on page 126.
Each touch of [MUTE Input/GUIDE] changes
the setting as follows:
! MUTE — Muting
! ATT — Attenuation
! Normal — Volume does not change
p Operation returns to normal when the cor-
respond action is ended.
p When "SD" or "USB" selected as the AV
source, the sounds are not muted or attenu-
ated even when the navigation guidance
and beep outputs.
p When "SD" or "USB" is selected as the AV
source, the AV sounds, the navigation gui-
dance and beep sounds are mixed and the
volume can be adjusted simultaneously.
Important Notice regarding Volume of
Navigation Voice Guidance when Playing
Audio Files from USB or SD
If music files stored on an external storage device
(USB, SD) are played when the system guides the
route (i.e., a destination has been selected and
the system is routing you to a destination), the vo-
lume of the navigation guidance voice will be the
same as the volume of the music files being
played, even if a different volume level has been
selected on "Master" or "Voice" or "Dynamic Vo-
lume" in the "Sound settings" menu.
128
Engb

Setting the rear output

The navigation system's rear output can be
used for a full-range speaker or subwoofer
connection. If you switch Rear SP to Sub W,
you can connect a rear speaker lead directly to
a subwoofer without using an auxiliary amp.
Initially, the navigation system is set for a rear
full-range speaker connection (Full).
p AVIC-F9110BT is not compatible with the
wiring that the subwoofer is directly con-
nected to rear speaker leads. Always use
the setting with [Full].
Touch [Rear SP] on the "AV System Set-
1
tings" menu.
= For details, refer to Displaying the "AV Sys-
tem Settings" menu on page 126.
2 Touch [Rear SP] to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select Full.
When a subwoofer is connected to the rear
output, select Sub W.
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)

Switching Auto PI seek

The navigation system can automatically
search for a different station with the same
programming, even during preset recall.
% Touch [Auto PI] on the "AV System Set-
tings" menu.
= For details, refer to Displaying the "AV Sys-
tem Settings" menu on page 126.
Touching [Auto PI] switches between [On]
and [Off].