Customizing The Labels For The Keys Of The Td 200 - Siemens S7-200 System Manual

Installing your Text Display (TD) Device

2.5 Customizing the Labels for the Keys of the TD 200

Mounting the TD 100C
Use the following procedure to complete the mounting of your TD 100. See figure below.
1. Remove the gasket from the protective cushion.
2. Place the supplied gasket on the frontplate of the TD device.
3. Fit the TD 100C into the cutout you made in the mounting surface.
4. Attach the special mounting brackets (included) to the TD 100C.
5. Tighten the mounting screws on the mounting brackets to secure the TD 100C to the
2.5 Customizing the Labels for the Keys of the TD 200
Customizing the Labels for the Keys of the TD Device
The TD 200 allows you to define the functions for four of the nine keys (or buttons) on the
standard faceplate. You can remove the label insert of the TD 200 and designate the
functions assigned to those user-defined keys. You can also replace the standard TD 200
insert with your own custom insert for the user-defined keys.
You must remove (at least partially) the TD housing in order to access the label insert from
underneath the front cover of the TD device.
Modifying the Label Insert of the TD 200
1. Remove the three screws on the back of the TD device and remove the front cover from
2. Remove the label insert by pulling the label insert tab out of the label slot with a pair of
3. Turn the label insert over and create your own label design. (The reverse side of the label
4. Insert the label by placing the corner of the label into the label slot.
36
panel.
Figure 2-5 Mounting the TD 100C
the housing.
pointed tweezers.
insert is blank.)
Text Display (TD) User Manual
System Manual, 08/2008, A5E00765548-03