Installation
WARNING: Risk of electrical shock.
WARNING: Hazardous voltages exist within enclosure. Installation
and service should be performed only by trained service personnel.
CAUTION: Read complete instructions prior to installation and operation
of the meter.
Notes:
•
There is no need to remove the meter from its case to complete the
installation, wiring, and setup of the meter.
•
Installation must only be performed by qualified personnel, and in
accordance with local governing regulations.
Unpacking
Remove the meter from box. Inspect the packaging and contents for damage. Report
damages, if any, to the carrier.
If any part is missing or the meter malfunctions, please contact your local Siemens
representative for assistance.
Panel Mounting Instructions
1.
Prepare a standard 1/8 DIN panel cutout – 92 mm x 45 mm (3.622 " x 1.772 ").
•
Clearance: allow at least 102 mm (4 ") behind the panel for wiring
•
Panel thickness: 1.0 mm to 6.4 mm (0.04 " to 0.25")
•
Recommended minimum panel thickness to maintain Type 4X
rating: 1.5 mm (0.06 ") steel panel, 4.1 mm (0.16 ") plastic panel.
Troubleshooting
Refer to
2.
Remove the two mounting brackets provided with the meter. Back off the two
screws so that there is 6.4 mm (¼ ") or less through the bracket. Slide the bracket
toward the front of the case and remove.
3.
Insert meter into the panel cutout.
4.
Install mounting brackets and tighten the screws against the panel. To achieve a
proper seal, tighten the mounting bracket screws evenly until meter is snug to the
panel along its short side. DO NOT OVER TIGHTEN, as the rear of the panel may be
damaged.
7ML19985JS01
on page 50 for more details.
SITRANS RD200 – OPERATING INSTRUCTIONS
Page 9