I Call channel programming
The call channel key is used to select the default channel,
however, you can program your most often-used channel in
each channel group for quick recall.
q Push [DIAL] for 1 sec. several times
to select the desired channel group
1
2
(INT, USA*
, ATIS*
) to be pro-
grammed.
1
2
*
U.K version only, *
German version only
w Push [16•
] for 1 sec. to select the
C
call channel.
• "CALL" and the call channel number
appear.
e Push [16•
] again for 3 sec. (until a
C
long beep changes to 2 short beeps)
to enter call channel programming
condition.
• Call channel number to be programmed
flashes.
r Push [Y]/[Z] to select the desired
channel.
t Push [16•
] to program the dis-
C
played channel as the call channel.
• The
call
channel
number
flashing.
stop
I Lock function
This function electronically locks all keys (except for [PTT],
[SQL•
] and [Hi/Lo•
MONI
changes and function access.
➥ Push [Hi/Lo•
] for 1 sec. to turn the lock function ON
and OFF.
I Signal strength indicator
The received signal strength level is indicated by number of
bars as below.
This indicator can be hidden by using the SET mode (p. 20) if
desired.
Indication
Signal
Strong
Middle
strength
I Monitor function
The monitor function releases the noise squelch mute manu-
ally. This function is convenient when receiving a weak sig-
nal, or when adjusting the volume level, etc.
➥ Push [SQL•
] for 1 sec. and keep holding to activate
MONI
the monitor function.
• "
" appears and audio is emitted.
BASIC OPERATION
]) to prevent accidental channel
Appears while the lock
function is used.
No signal or
Weak
very weak
4
4
10