Installation - Gaggenau VL 051-107 Operating And Assembly Instructions Manual

6.5 Installation

41 3
6 0
8 ,5
7 1 0
Fig. 7
Fig. 8
12
1 7 0
2 0 5
4 6 0
2 5 0
The hob ventilator can be installed next to one or
between two built-in Vario appliances.
Choose the suitable connection variant (see
Page 13) before beginning with installation.
– Produce the recess for the appliance. Proceed
as indicated on the installation sketch and the
dimension table (Fig. 7). When installing several
Vario appliances at the same time, please pay
attention to the dimensions specified in the type
list. Important: The angle between the cut
surface and the worktop must amount to 90°.
– Mark the centre of the recess exactly. Secure
the securing rail in the recess at the rear with the
included wood screws. Make sure that the lugs
of the securing rail lie on the worktop and that the
centre marking of the securing rail is precisely
flush with the centre marking on the worktop.
(Fig. 8) When installed in a stone worktop, the
securing rail must be adhered with a suitable
adhesive.
– Make sure that the securing rail is fitted at a
right angle to the surface of the worktop.
– Remove the protective film from the included
sealing tape and stick the sealing tape onto
the edge of the worktop so that the edge of the
appliance when it is installed halves the sealing
tape. The ends must not overlap.
– Define connection to the fan module before
finally lowering the appliance into the worktop.
Before sawing out the base plate, check whether
the depth of the base area is sufficient for the fan
module.