Uniden UBC800XLT Owner's Manual page 76

UB356ZH.fm Page 76 Wednesday, December 19, 2007 11:28 AM
F
Select a site
Edit Band Plan
You can enter up to 3 band plans. Select the plan to enter or edit, then follow the
prompts to enter the Base Frequency, Channel Step, and Channel Offset for the
site.
Setting Control-Channel Only Mode
[MENU]
Program System
Select a trunked system
Edit Site (current)
F
Select site
Set C-Ch Only
This setting determines the frequencies you need to enter for Motorola systems.
Select your setting, then press
On — You only need to enter control channel frequencies.
Off — You must enter all voice and control channel frequencies.
Note: The scanner defaults to On.
Setting Site Location Information
[MENU]
Program System
Select a trunked system
Edit Site (current)
F
Select a site
Set LocationInfo
This setting control whether the system is automatically enabled and disabled
when you connect a GPS to the scanner.
Set Latitude — Enter the system's latitude using the format you selected in the
system settings.
Set Longitude — Enter the system's longitude using the format you selected in
the system settings.
Set Range — Set the system's range using the units you selected in the system
settings.
Set GPS Enable — Depending on the data received from the GPS, the L/O
status of the site is automatically controlled.
76
F
F
F
F
F
F
.
F
F
F
F
M
MESL