Denon AVR-4310 Owner's Manual page 36

ENGLISH
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey Auto Setup)
Subwoofer Level Error Message and How to Adjust
The optimal level of the subwoofer channel is 75 dB. During subwoofer level measurement (" STEP2 : Speaker Detection" (vpage 29),
Perform Audyssey Auto Setup, 1 - q), an error message is displayed when the subwoofer level is outside the 72 ~ 78 dB range. When using a
subwoofer with built-in amplifier (active type), adjust the subwoofer volume so that the subwoofer level is within the 72 ~ 78 dB range.
1
Select "SW Level
Matching" and then
ENTER
press .
2
Select "SW Test
Start" and then press
ENTER .
Subwoofer level
measurement begins.
During measuring, a
"Testing ..." message is
displayed.
The measured level
appears on the level
indicator after about 3 ~ 5
seconds.
Red
If the measured level is outside the 72 ~ 78 dB range, the level
b
indicator is red.
ENTER
b When measuring stops, press

Main remote control
operation buttons
3
Adjust the volume
control
subwoofer so that
the measured level is
within the 72 ~ 78 dB
range.
b If the measured level is within the 72 ~ 78 dB range, the level
indicator is blue.
4
When the measured level is within the 72 ~ 78 dB
range, press
5
Select
then press
Proceed to " STEP2
Speaker
(vpage 29),
Audyssey Auto Setup, 1
- w.
.
:Displaying the menu
Cancel the menu
on your
Blue
ENTER
.
"Next" and
ENTER .
:
Detection"
d :Perform
:Moves the cursor
(Up/Down/Left/Right)
Check the Measuring Results and
d :
Equalizer Type after Audyssey Auto
Setup (Parameter Check)
This is displayed after the Audyssey Auto Setup procedure is
completed.
1
Press to select
i
"Parameter Check",
and then press
ENTER
or p .
2
Press to select the item you want to check, and
ui
ENTER
then press or .
p
Speaker Config. Check Distance Check
Crossover Freq. Check EQ Check
3
Press to select the channel you want to check.
ui
The measurement result of each speaker is displayed.
When you selected "EQ Check" in step 2, press
b
Correction curve you want to check ("Audyssey" or "Audyssey
Flat").
When you want to check another item, press
b
RETURN
Pressing returns you to step 2; from there, proceed to
steps 2 and 3.
If you set "Restore" to "Yes", you can return to the Audyssey Auto
Setup measurement result (value calculated at the start by MultEQ
XT) even when you have changed each setting manually.
:Confirm the setting :Return to previous menu
Channel Level Check
ui to select the
RETURN
.