Table of Contents
Advertisement
P
ROGRAMMING THE TIMER
The timer can be programmed to start up and shut down to fit in
with your needs.
Programming start up
• Press the
ON button. The start-up time and message "ON
TIMER" flash on the remote control display (fig. 25).
• Press the
or
appliance to start up.
• When that time is reached, press the SET button to confirm
(fig. 26). The message "ON TIMER" appears on the remote con-
trol display and the
to indicate that the timer is active.
Programming shutdown
• Press the
OFF button. The shutdown time and the messa-
ge "OFF TIMER" flash on the remote control display (fig. 27).
• Press the
or
appliance to shut down.
• When that time is reached, press the SET button to confirm
(fig. 28). The message "OFF TIMER" appears on the remote
control display and the
appliance to indicate that the timer is active.
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
...
IF IS DISPLAYED
LOW TEMPERATURE
(frost prevention)
PROBE FAILURE
(sensor damaged)
buttons to set the time you want the
symbol is displayed on the appliance
buttons to set the time you want the
symbol is displayed on the
28
...
DO
WHAT SHOULD I
?
The appliance is fitted with
a frost protection device to
avoid excessive formation
of ice.
The appliance starts up
again automatically when
the defrosting process is
completed.
If this is displayed, contact
your local authorised servi-
ce centre.
...
IF IS DISPLAYED
FULL TANK
FAILURE 1
)
(pump failure
14
25
26
27
...
DO
WHAT SHOULD I
Empty the tank on the back
of the appliance and replace
it correctly.
The continuous drain hose is
not connected correctly or is
obstructed and the air condi-
tioner is draining into the tank.
NB: in dehumidifying mode, it
is normal for this message to
appear.
If this is displayed, contact
your local authorised servi-
ce centre.
?
Advertisement
Table of Contents
