Table of Contents
Advertisement
The speeds available are:
Minimum speed: when maximum silent operation is
desired.
Medium speed: when the noise level needs to be low
but with a good comfort level.
Maximum speed: to reach the desired tempera-
ture as soon as possible.
the best fan speed based on the temperature selected and the
environmental conditions.
The most suitable temperatures during the summer range from 24
to 27°C. However, not to set a temperature much below the out-
door temperature.
DEHUMIDIFING MODE
This is ideal for reducing humidity in the room (spring and au-
tumn, damp rooms, rainy periods, etc.). For this type of use, the
appliance must be set up as for air conditioning mode. That is,
the air exhaust hose (B2) must be fitted to the appliance to allow
the humidity to be discharged outside.
To correctly set this mode:
•
Touch repeatedly the MODE key until the dehumidifier
symbol appears.
FAN MODE
When using this mode, the air exhaust hose (B2) does not need
to be attached to the appliance.
To correctly set this mode:
Touch repeatedly the MODE key until the fan symbol
•
appears.
•
Select the desired fan speed by touching the
The speeds available are:
Minimum speed: when maximum silent operation is
desired.
Medium speed: when the noise level needs to be low
but with a good fan level.
Maximum speed: for maximum fan power.
The appliance automatically chooses
SELECT THE TEMPERATURE SCALE
The temperature can be displayed in °C or °F.
To change the temperature unit of measure, exit the operating
mode by pressing the
key for about 20 seconds.The appliance will beep.
PROGRAMMING THE TIMER
The timer allows for the delayed start up or shut down of the
appliance. This function will prevent wasting electricity by opti-
mising the operating periods.
How to program delayed start up
•
Plug in the appliance and set to standby.
•
Touch the timer key (C3). The timer symbol (C12) and hours
light up.
•
Use the + (C4) or - (C5) key to set the number of hours until
the appliance should start up.
•
The appliance will start to operate in the same operating
mode that was previously set.
Start up can be programmed at any time within the 24 hours
that follow. A few seconds after the timer is set, the setting is
acquired. The timer symbol stays lit and the display returns to
standby.
To cancel the timer program, touch the timer key (C3) twice. The
timer symbol (C12) will go off.
How to program delayed shut down.
•
While the appliance is on in any operating mode, delayed
shut down can be programmed.
•
Touch the timer key (C3). The timer symbol (C12) and hours
light up.
Use the + (C4) or - (C5) key to set the number of hours until
•
the appliance should shut down.
key.
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer symbol stays
lit.
At the pre-set time, the appliance goes into Standby.
To cancel the timer program, touch the timer key (C3) twice. The
timer symbol (C12) will go off.
21
key then keep touched the MODE
Advertisement
Table of Contents
