Ventilation; Programming The Timer; To Set The Delayed Start Function; To Set The Delayed Stop Function - DeLonghi Pinguino K900 Instructions For Use Manual

GB 8-07-2003 15:32
Once the dehumidifying function has been selected, the fan
speed cannot be changed. The appliance will automatically
select the correct fan mode.

VENTILATION

Adjust the fan speed by pressing the "FAN" (Q) button, as illustra-
ted in the air conditioning function.
Bear in mind that the higher the speed, the greater the volume of
air filtered; by selecting the "Silent" speed, less air is filtered, but
the noise level is low.
"AUTO" function cannot be selected in this mode.
The display will show the fan speed selected.

PROGRAMMING THE TIMER

The timer programs the appliance to switch on and switch off. This
will save electrical energy by optimizing the operating times.
The timer is set using the buttons + (F) or – (G); these increase and
decrease by one hour at a time, but if pressed for more than 2
seconds will automatically change the time more quickly, up to a
maximum of 24 hours.
How to set the delayed start function
• Connect the appliance to the mains supply and press ON/OFF
button: next, select the required operating mode (temperatu-
re, fan speed etc.)
• Press the ON/OFF button again: the appliance will go into
stand-by mode.
• Press the timer button (I): on the display the two central seg-
ments will start to flash.
• Set the number of hours after which the appliance should swit-
ch on, by pressing the + or – buttons.
The indicator (L) on the display will continue to flash until the
appliance starts operating.
The appliance can be programmed for up to 24 hours in advance.
How to set the delayed stop function
• The appliance can be programmed for delayed stop from any
of the operating modes (air-conditioning/dehumidifying/venti-
lation.
• Press the Programmer button (I): on the display the two central
segments will start to flash.
• Set the number of hours after which the appliance should swit-
ch off by pressing the + or – buttons.
The indicator (L) on the display will continue to flash until the
appliance switches itself off. It will then go into Stand-by mode.
.
12
Pagina 12
O p e r a t i o n
"Silent"
speed
"Min"
speed
"Max"
speed