Burner Ring; Burner Cover; Ignition Electrode (A); Thermo Sensor (B) - Electrolux EHT632X Instruction Book

ELECTROLUX WARRANTY AUSTRALIA
Nothing in this warranty, limits any
rights you may have under the
Trade Practices Act or any other
Commonwealth or State legislation.
Such rights cannot be changed by
the conditions in this warranty.
Subject to the conditions below,
this appliance is warranted by
Electrolux Home Products Pty. Ltd.
A.B.N. 51 004 762 341, (the
"Company"), to be free from
defects in materials and
workmanship for a period of 24
months following the date of
purchase (the "Warranty Period").
Conditions of the warranty:
1 During the Warranty Period the
Company, or its service agent,
will only pay the cost of repairing
or replacing all Company parts on
your appliance which the
Company finds to be defective.
2 The Company will decide if there
are any defects in material and/or
workmanship.
3 Light globes, batteries and filters
are replaceable parts and are not
covered under this warranty.
4 This warranty applies only for
mainland Australia and
Tasmania.
5 The appliance must be installed
and operated in accordance with
the Company's instructions.
6 This warranty does not apply to
normal wear and tear, or any
service, which is needed after an
accident, alteration, negligence,
misuse, fire or flood.
7 This warranty does not apply to
damage caused if your appliance
has been dismantled, repaired or
serviced by any person other
than someone authorised by the
Company.
8 If you live outside the service area
of the Company or one of its
service agents, this warranty does
not cover the cost of transport of
the appliance for service nor the
service agent's travelling costs to
and from your home.
9 If you are required to transport the
appliance to the Company or its
service agent, you must ensure it
is securely packed and insured.
The Company does not accept
any responsibility for loss or
damage of the appliance prior to it
being received by the Company
or its service agent.
18
Burner cover/burner ring
Together with the burner ring the burner
cover forms a space where the final
mixture of gas and air takes place in
order to make the gas burn correctly.
Please note: It is consequently very
important that the individual burner
cover/ring is placed correctly on the
burner. The burner ring has been
provided with holes for the ignition
electrode, and the thermo sensor.
If the burner cover/ring are wrongly
placed the burner will operate
incorrectly, and the burners may be
damaged within at short space of time.

Ignition electrode (A)

Each burner has been provided with an
ignition electrode. As long as the
operating knob is depressed, the
automatic ignition will ensure that a
spark is emitted between the ignition
electrode and the burner cover.

Thermo Sensor (B)

The hob unit features fully-secured gas
taps (thermo-fuse)
In case the flame goes out, the thermo
sensor automatically prevents gas
admission after a few seconds (max. 90
seconds).
Note: Gas admission is always allowed
while the operation button is pressed -
See start-up procedure

Burner ring

Burner cover

Correct
Wrong
Burner Main nozzle
7