Table of Contents
Advertisement
9
and care
maintenance
Stainless steel top
• All grades of stainless steel may stain, discolor or attain
an adhering layer of grime in normal operation. To archive
maximum surface appearance, stainless steel must be kept
clean by regularly using the following cleaning procedures,
thus ensuring good performance and long service life.
Wash with warm soapy water and rinse with clean water.
Where the stainless steel has become extremely dirt with
signs of surface discoloration,(due to periods of neglect or
misuse )use a stainless steel cleaner.
•Do not use the stainless steel top as a work table.
Burner caps & crowns
•These can all be lifted off and removed for separate
cleaning.
•Ensure burner caps and crowns are thoroughly dried
after cleaning or spillage.
•When cleaning the burner, ensure that all the flame ports,
injector hole and other holes are free of any blockage.
(Fig 13,14)
What to do if
Phenomenon
Burner will not light...
Burner lights back to injector...
Burner has explosive ignition...
lgnitor not sparking...
WARNING:-
Do not spray aerosols in the vicinity of this hob while in operation. Some propellant gases can break down when
heated and produce corrosive vapours which will attack some materials.
Articles which are made from flammable materials should not be stored in drawers or cupboards immediately below
this hob.
Do not store articles within 50mm of the base.
Do not touch spark ignitor while lighting the burner.
Where this appliance is installed in a marine craft or in caravans, it shall not be used as a space heater.
•If necessary, use a matchstick or brush to clean ports.
•After cleaning, ensure the burner caps are
reassembled properly into position.
•After cleaning, when assembling the burner crown and
caps, care must be taken to ensure the spark plug is not
knocked. The spark plug will crack if knocked and may
give rise to flame ignition problem.
Reason
Air
in
gas
line
Blockage
in
line
Ignition
not
sparking
Battery
is dead
Burner
not fitted
correctly
Excessive
lint
up
of
burner
Excessive
gas pressure
Excessive
gas pressure
Electrode gap
excessive
lgnitor connections loose
Battery is
dead
Solution
Purge gas line
Trace
back
Check
lead
Replace
Fit
burner in
mixing
tube
Remove
Check gas regulator pressure
adjust
if necessary
Check gas regulator pressure
adjust if
Check gap,
4-5 mm
Check connections to
replace
Change
clear
&
electrode
&
battery
correct
position
&
clean
burner
&
&
necessary
adjust
if not between
ignitor,
if
faulty
a
new battery
Advertisement
Table of Contents
