Download Print this page

Solutions To Common Problems; Surface Burner Do Not Light; Burner Flame Only Lights Half Way Around Burner; Burner Flame Is Orange - Electrolux GAS COOKTOP Use And Care Manual

30" cooktop/36" cooktop
Hide thumbs


Table of Contents

Solutions to common problems

Before you call for service, review the following list. It may save you time & expense. The list includes
common occurrences that are not the result of defective workmanship or materials in this appliance.
Surface burners
• Surface control knob has not been completely turned to
do not light.
Surface Control knob to
control knob to desired fl ame size.
• Be sure gas supply valve is open.
• Burner ports are clogged. Clean burner. See Cleaning the burner grates, burner
caps, burner heads in general care & Cleaning section. With the burner off,
clean ports with a small-gauge wire or needle.
• Power cord is disconnected from outlet (Electric ignition models only). Be sure
cord is securely plugged into the outlet.
• Electrical power outage (electric ignition models only). Burners can be lit
manually. See Setting Surface Controls in this Use and Care Guide.
Burner fl ame only
• Burner ports are clogged. With the burner off, clean ports by using a small-
lights half way
gauge wire and needle.
around burner
• Moisture is present after cleaning. Lightly fan the fl ame and allow burner to operate
until fl ame is full. Dry the burners thoroughly following instructions in the General
Cleaning section.
Burner fl ame is
• Dust particles in main line. Allow the burner to operate a few minutes until fl ame
turns blue.
• In coastal areas, a slightly orange fl ame is unavoidable due to salt air.
Questions or for service call:
Before you call
and push in and until burner ignites and then turn
position. Turn the


Table of Contents