Table of Contents
Advertisement
Configuration
(Standalone)
Sound-Active
Mode
Sound Sensitivity
Automatic Mode
Program Speed
Page 14 of 20
Set the product in one of the standalone modes to control without a DMX controller.
·
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode (Static,
Automatic, or Sound-Active) to a DMX string connected to a DMX controller.
Products in standalone mode may transmit DMX signals that could interfere with
the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER> and Snd1 (3-color) or Snd2 (7-color) shows on the display.
3.
Use <UP> or <DOWN> to select the desired Sound-Active program.
4.
Press <ENTER>.
To set the sound sensitivity, follow the instructions below:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> or <DOWN> to select the desired sound sensitivity (u 0–u100).
3.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To select an auto program, do the following:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER> and P 1–P 4 shows on the display.
3.
Use <UP> or <DOWN> to select the desired auto program:
·
P 1 - 3-color snap
·
P 2 - 3-color fade
·
P 3 - 7-color snap
·
P 4 - 7-color fade
4.
Press <ENTER>.
To set the auto program speed, follow the instructions below:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> or <DOWN> to select the desired auto program speed
(S 1–S100, slow to fast).
3.
Press <ENTER>.
Wedge™ Tri User Manual
Advertisement
Table of Contents
