Bios Setup - Abit LM6E Pentium II User Manual

A-6
Installing CPU fan power connector
FAN: There is a specific orientation. Connect the three-threads fan power cable
to the fan header on the motherboard.
Pin number
1
2
3
Pin number
1
2
3
Adjusting other jumpers
Some jumpers are reserved for future functions or are not to be adjusted in
normal operation. Adjust them according to the following recommendations.
CCMOS ：Always put jumper on pin 1 and pin 2, this is default setting.

BIOS Setup:

steps described above and completed the installation, when you power the
computer on, you will see the following message displayed
PRESS DEL TO ENTER SETUP
Press immediately Del key to enter BIOS Setup. Select Load Setup Defaults,
than enter CPU Soft Menu to set CPU parameters.
FAN1 (CPU FAN)
Name of the signal or signification
Sense
+12V
Control On/Off
FAN2 / FAN3
Name of the signal or signification
Sense
+12V
Ground
Parameters and CPU settings After you have followed the
Appendix A
Watch the pin position and
the orientation