Abit LM6E Pentium II User Manual page 54

3-26
PM Timer Events:
When one of the specific occurs, the count down made for entry in power
saving mode goes back to zero.
Since the computer will enter a power saving mode only after an
inactivity delay specified (time specific for Doze, Standby and Suspend
modes) and after it has no activity, during this time period, any event will
cause the computer to re-count the time elapsed. Resume events are
operations or signals that cause the computer to resume time counting.
➤VGA Active Monitor:
If there is any VGA data transfer or any I/O activities, this will cause
the computer to re-count the time elapsed.
➤IRQ [3-7, 9-15], NMI:
If any IRQ or NMI (Non-Mask Interrupt) activities occur, this will
cause the computer to re-count the time elapsed.
➤IRQ8 Break Suspend :
Supports the RTC alarm wake up from suspend function (via IRQ8).
➤IDE Primary Master:
If any IDE primary master I/O activity occurs, it will cause the
computer to re-count the time elapsed.
➤IDE Primary Slave:
If any IDE primary slave I/O activity occurs, it will cause the
computer to re-count the time elapsed.
➤IDE Secondary Master:
If any IDE secondary master I/O activity occurs, it will cause the
computer to re-count the time elapsed.
➤IDE Secondary Slave:
If any IDE secondary slave I/O activity occurs, it will cause the
computer to re-count the time elapsed.
Chapter 3