Troubleshooting - Honeywell GasAlert Extreme User Manual

GasAlert Extreme
User Manual

Troubleshooting

If a problem occurs, refer to the solutions provided in Table 14. If the problem persists, contact
Problem
The detector does not activate.
The detector enters alarm mode immedi-
ately when it is activated.
The start up self-test fails during one of the
checks.
46
Table 14. Troubleshooting Tips
Possible Cause
No battery
Depleted battery
Damaged or defective detector
Reversed battery
Sensor needs to stabilize
Low battery alarm
Sensor alarm
General fault
Alarm setpoints are incorrect
BW Technologies by Honeywell.
Solution
Install a battery. Refer to
tery or Sensor.
Replace the battery. Refer to
Battery or Sensor.
Contact BW Technologies by
Reinstall the battery correctly.
Used sensor: wait 60 seconds.
New sensor: wait 5 minutes.
Replace the battery. Refer to
Battery or Sensor.
Replace the sensor. Refer to
Battery or Sensor.
Contact BW Technologies by
Reset the alarm setpoints. Refer to
ting Gas Alarm Setpoints.
Replacing the Bat-
Replacing the
Honeywell.
Replacing the
Replacing the
Honeywell.
Reset-