Appendix I. Operation Modes And Troubleshooting Guide - Honeywell Fire-Lite Alarms BEAM355A Installation And Maintenance Instructions Manual

APPEnDix i. oPERATion MoDES AnD TRouBlEShooTinG GuiDE

Modes *Red Yellow and
See Remote
Note Trouble
Below
Normal Off Off
Alignment Off On
Alarm On Off
Trouble-Drift Off 3 Quick
Comp Elevated Blinks
Signal
Trouble-Drift Off 2 Quick
Comp Reduced Blinks
Signal
Trouble-Signal Off 2 Quick
Over Range Blinks
Trouble-Beam Off 4 Quick
Blockage Blinks
Response
Initialization- Off Blink until
Power on complete
Initialization- Off Blink until
alignment exit complete
Local Test On Blinks out
(BEAM355SA) the amount
Pass Result of drift used.
Local Test Off On until
(BEAM355SA) reset or
Fail Result time-out
Local Test Off On until
(BEAM355A) reset or
Fail time-out
Local Test On Blinks out
(BEAM355A) the amount
Pass Result of drift used.
Note: Green and Red LEDs are controlled by the control panel.
Blinks output by Yellow LED and Remote Trouble Output once the device has
passed a local remote test:
Percent the detector has drifted
<10%
<20%
<30%
<40%
<50%
<60%
<70%
<80%
<90%
<100%
F300-30-00
*Green Remote Dual Digital Display
See Alarm
Note
Below
Blink Blink Off
Blink Blink On, Relative amount
of signal 0-99, or – if
automatic gain resetting,
or Lo if signal is too low
Off On Off
Blink Blink Off
Blink Blink Off
Blink Blink Off
Blink Blink Off
Blink Blink Off
Blink Blink Off
Off On Off
Blink Blink Off
Blink Blink Off
Off On Off
Number of blinks output
None
1
2
3
4
5
6
7
8
9
Initiating means
Successful completion of
initialization or detector
reset
Alignment Switch
Smoke, Test Filter,
RTS451 Test Stations
Long Term Drift
Reference Out of Range
Long Term Drift
Reference Out of Range
Increase of Reflected
Signal
Beam Blockage
Apply Power from
discharged state.
Depressing RESET
switch after alignment
Panel or RTS451/KEYA
Panel or RTS451/KEYA
test input
Panel or RTS451/KEYA
test input
Panel or RTS451/KEYA
10
Comments & Troubleshooting Tips
• Sunlight into detector or reflector.
• Re-Align detector.
• Clean detector and reflector.
• Inspect line of sight between detector
and reflector for reflective objects in
the pathway.
• Remove blockage.
• Faulty unit.
Remains in alarm until reset or time-out
Remains in fault until reset or time-out
Remains in fault until reset or time-out
Remains in alarm until reset or time-out
I56-2543-004R