Appendix I. Operation Modes And Troubleshooting Guide - Honeywell FireLite BEAM355 Installation And Maintenance Instructions Manual

APPEnDix i. oPERATion MoDES AnD TRouBlEShooTinG GuiDE

Modes *Red Yellow and
See Remote Trouble
Note
Below
Normal Off Off
Alignment Off On
Alarm On Off
Trouble-Drift Off 3 Quick Blinks
Comp Elevated
Signal
Trouble- Off 2 Quick Blinks
Drift Comp
Reduced
Signal
Trouble-Signal Off 2 Quick Blinks
Over Range
Trouble-Beam Off 4 Quick Blinks
Blockage
Response
Initialization- Off Blink until complete Blink
Power on
Initialization- Off Blink until complete Blink
alignment exit
Local Test On Blinking the amount
(BEAM355S) of drift used
Pass Result
Off On until reset or
Local Test
(BEAM355S) time-out
Fail Result
Local Test Off On until reset or
(BEAM355) time-out
Fail
Local Test On Blinking the amount
(BEAM355) of drift used
Pass Result
Note: Green and Red LEDs are controlled by the control panel.
Blinks output by Yellow LED and Remote Trouble Output once the device has
passed a local remote test:
Percent the detector has drifted
<10%
<20%
<30%
<40%
<50%
<60%
<70%
<80%
<90%
<100%
F300-29-00
*Green Remote
See Alarm
Output Note Output
Below
Blink Blink
Blink Blink
Off On
Blink Blink
Blink Blink
Blink Blink
Blink Blink
Blink
Blink
Off On
Blink Blink
Blink Blink
Off On
Number of blinks output
None
1
2
3
4
5
6
7
8
9
Dual Digital Display Initiating means
Off Successful
completion of
initialization or
detector reset
On, Relative amount Alignment Switch
of signal 0-99, or – if
automatic gain resetting,
or Lo if signal is too low
Off Smoke, Test Filter,
RTS451 Test
Stations
Off Long Term Drift
Reference Out of
Range
Off Long Term Drift
Reference Out of
Range
Off Increase of
Reflected Signal
Off Beam Blockage
Off Apply Power from
discharged state.
Off Depressing
RESET switch
after alignment
Off Panel or RTS451/
KEY
Off Panel or RTS451/
KEY test input
Off Panel or RTS451/
KEY test input
Off Panel or RTS451/
KEY
9
Comments & Troubleshooting Tips
• Sunlight into detector or reflector.
• Re-Align detector.
• Clean detector and reflector.
• Inspect line of sight between
detector and reflector for reflective
objects in the pathway.
• Remove blockage.
• Faulty unit.
Remains in alarm until reset or time-out
Remains in fault until reset or time-out
Remains in fault until reset or time-out
Remains in alarm until reset or time-out
I56-2425-007R