Power Errors; Device Failure Errors - HP BladeSystem c7000 Setup And Installation Manual

Power errors

Power errors can occur because of insufficient power to an enclosure. Power errors can occur on
server blades, storage blades, or interconnect modules.
To correct a power error:
1. Use the arrow buttons to navigate to Fix This, and press OK.
2. Review and complete the corrective action suggested by the Insight Display. In most cases,
you must either add power supplies to the enclosure or remove the indicated components.

Device failure errors

Device failure errors occur when a component has failed. Device failure errors can occur on all
components.
To correct a device failure error:
1. Use the arrow buttons to navigate to Fix This, and press OK.
2. Review and complete the corrective action suggested by the Insight Display. In most cases,
you must remove the failed component to clear the error.
3. If applicable, replace the failed component with a spare.
NOTE:
the error.
60 Troubleshooting
When a power input failure error occurs, you must repair failed power input to clear