Installing The Sheet Metal Grommet; Installing The Breaker Panel Brackets; Installing The Breaker Panel Into The Rack; Dc Input Module - HP BladeSystem c7000 Setup And Installation Manual

Installing the sheet metal grommet

The sheet metal grommet protects the cables that run through the opening on the top of the rack.
1. From the rear of the rack, unscrew the two top plate nuts, and then remove the rack top.
2. Discard the plate and nuts.
3. Align and center each grommet to the rack frame edge, and then push the grommet onto the
edge of the sheet metal

Installing the breaker panel brackets

There are three sets of breaker panel brackets:
Front mounting locking brackets—Installed on the front of the breaker panel
Rack support brackets—Installed on each side of the breaker panel
Slider rail brackets—Installed on each side of the rack
To install the breaker panel brackets:
1. Using the M4 screws provided, install the front mounting locking brackets by attaching the
two front mounting locking brackets to the front of the breaker panel.
2. Using the remaining screws, install the rack support brackets by attaching the two rack support
brackets to each side of the breaker panel.
3. Install the slider rail brackets.
a. Install the four cage nuts into the front mounting rails of the rack, two per side in the lower
U space allocated for the breaker panel.
b. Install cage nuts into the top and bottom holes of that U.
c. Install cage nuts into the top and bottom holes of that U.
d. Verify that the single threaded hole is positioned to the front of the rack. The two cage
nuts are for the front locking brackets on the front of the breaker panel.
e. Using the M5 screws provided, secure the front hole of the slider rail bracket.
f. Secure the rear of each slider rail bracket to the rear rack mounting rails.

Installing the breaker panel into the rack

1. Align the rack support brackets on the breaker panel with the rail brackets, and slide the
breaker panel into the rack.
2. Secure the breaker panel with the screws provided.

DC Input Module

1. Remove the DC input module cover.
Component installation 37