Reassembling The Mopping Nozzle - Philips AquaTrio FC7070 User Manual

6.3.2 Cleaning the dirty water tank
• Empty the dirty water tank after every use
and when the tank full/tank empty light lights
up continuously.
•
Clean the dirty water tank after every use
to prevent the growth of bacteria and an
unpleasant smell.
switch off the appliance, place the appliance
1
upright in parking position ('click') and pull the
plug out of the wall socket.
Remove the dirty water tank (see chapter
2
'Using your AquaTrio', section 'Emptying
the dirty water tank'). The dirty water tank
contains concentrated wastewater. Be careful
when you remove and empty it.
Pour the dirty water out.
3
Rinse the dirty water tank and its lid under
4
the tap, or clean the dirty water tank and its
lid in the dishwasher.
For extra thorough cleaning, you can pull up
5
the floater attached to the lid of the dirty
water tank. This enables you to rinse the
bottom of the sieve and the floater properly.
Place the dirty water tank back into the
6
appliance (see chapter 'Using your AquaTrio',
section 'Emptying the dirty water tank').
6.4 Reassembling the mopping
nozzle
First fit the side of the mopping brush with
1
the opening onto the projection in the
mopping nozzle. Turn the mopping brush a
little until the recess inside the mopping brush
fits onto the projection and press until fixed.
Then press the projection on the other side
of the mopping brush into the opening on the
other side.
Check if the inside of the mopping nozzle lid
2
and the mopping brushes are clean before
you place the mopping brush cover back into
the mopping nozzle.
If the inside is dry and clean, close the
3
mopping nozzle lid and press it until it is
locked ('click').
17