Philips AquaTrio FC7070 User Manual page 22

Problem
The appliance
stopped working.
The appliance
does not apply
water to the
floor because it
has picked up
something.
22
Possible cause
You released the
power-on button.
The clean water tank
may be empty or the
dirty water tank may
be full, although you
did not notice the
light indicating this.
The ventilation
openings are blocked.
The active protection
system may have
been activated for
three reasons: (1) the
appliance picked up
a foreign object, (2)
the mopping brushes
are too wet or (3)
you have moved
the appliance over a
carpet. The mopping
brushes automatically
stopped rotating
because they
encountered too
heavy resistance. The
appliance continues
to make a sound,
but it does not work
properly.
solution
The appliance is equipped with a safety lock. You first
have to push the unlock slide forwards to unlock the
power-on button and then you can press the power-
on button to switch on the appliance. Release the
unlock slide when the appliance switches on, but keep
the power-on button pressed (see chapter 'Using your
AquaTrio').
To check if this is the cause, switch on the appliance and
see if the tank full/tank empty light starts flashing or lights
up continuously. If the light flashes, fill the clean water
tank (see chapter 'Preparing for use', section 'Filling the
clean water tank'). If the light lights up continuously, empty
the dirty water tank (see chapter 'Using your AquaTrio',
section 'Emptying the dirty water tank').
Check all four ventilation openings for any objects that
block the ventilation openings. If necessary, remove these
objects. Let the appliance cool down before you continue
cleaning. see chapter 'Your AquaTrio' for the location of
the ventilation openings.
Release the power-on button to switch off the appliance.
Put the appliance upright in parking position ('click') and
pull the plug out of the wall socket. Open the mopping
nozzle lid, remove the mopping brush cover and remove
the object. Reinsert the mopping brush cover, close the
mopping nozzle lid, put the plug in the wall socket and
switch on the appliance again (see chapter 'Using your
AquaTrio', section 'Active protection system is activated').
If you find no object, the active protection system may
have been activated because the mopping brushes are
too wet (see next cause and solution) or because you
moved the appliance over a carpet. Pull the plug out
of the wall socket, open and close the mopping nozzle
lid, put the plug in the wall socket again, switch on the
appliance and start cleaning again.
If the above solutions did not help and the appliance still
does not work, switch on the appliance for at least 10
seconds. Then open and close the mopping nozzle lid,
switch on the appliance and start
cleaning again.