Philips AquaTrio FC7070 User Manual page 27

Aquatrio
Hide thumbs Also See for AquaTrio FC7070:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Problem
Possible cause
Water drips out
Water leaks from
of the appliance.
the clean water tank
because you have
not put the cap on
the clean water tank
or you have not
fastened this cap
properly.
Water leaks from
the clean water
tank because you
overfilled the clean
water tank.
Water leaks from
the dirty water tank
because you tilted
the upper body too
far backwards or
because you placed
the appliance on
its side. This caused
wastewater to run
out of the dirty water
tank.
I cannot remove
You probably tried
the mopping
to remove them by
brushes.
pulling at the wrong
side.
I cannot tilt
The appliance is
the appliance
locked in parking
backwards
position.
without the
nozzle coming off
the floor.
solution
Remove the clean water tank from the appliance. Put
the cap on the water tank if it was not there or turn the
cap clockwise to fasten it (see chapter 'Preparing for use',
section 'Filling the clean water tank').
Do not fill the clean water tank beyond the MAX
indication. If you do, water may spill from the clean water
tank when you fasten the cap (see chapter 'Preparing for
use', section 'Filling the clean water tank').
Do not tilt the upper body of the appliance too far
backwards, for instance when you clean under a low
table. Do not place the appliance on its side when
there is wastewater in the dirty water tank (see chapter
'Important', section 'Caution').
grab the lime green grips of the brushes and pull the
brushes up a little. Then you should be able to slide
them off the projection on the other side (see chapter
'Cleaning and maintenance', section 'Cleaning the
mopping nozzle').
Press the nozzle with your foot and release the appliance
from parking position (see chapter 'Using your AquaTrio',
section 'Pausing during use').
27

Advertisement

Table of Contents
loading

Table of Contents