Reassembling The Mopping Nozzle - Philips FC7070/61 User Manual

Rinse the dirty water tank and its lid under
4
the tap, or clean the dirty water tank and its
lid in the dishwasher.
For extra thorough cleaning, you can pull up
5
the floater attached to the lid of the dirty
water tank. This enables you to rinse the
bottom of the sieve and the floater properly.
Place the dirty water tank back into the
6
appliance (see chapter 'Using your AquaTrio',
section 'Emptying the dirty water tank').
6.4 Reassembling the mopping
nozzle
First fit the side of the mopping brush with
1
the opening onto the projection in the
mopping nozzle. Turn the mopping brush a
little until the recess inside the mopping brush
fits onto the projection and press until fixed.
Then press the projection on the other side
of the mopping brush into the opening on the
other side.
Check if the inside of the mopping nozzle lid
2
and the mopping brushes are clean before
you place the mopping brush cover back into
the mopping nozzle.
If the inside is dry and clean, close the
3
mopping nozzle lid and press it until it is
locked ('click').
If the mopping brushes are still too wet,
4
let them dry (see chapter 'Storing and
moving your AquaTrio', section 'Storing your
AquaTrio'). If the mopping brushes are too
wet, they encounter too heavy resistance
and will activate the active protection system
when you switch on the appliance. Make sure
the mopping brushes are dry before you start
cleaning your floors.
17