Philips AquaTrio FC7070 User Manual page 23

Problem Possible cause
The mopping nozzle
lid is not closed
properly. The sound
of the appliance
decreases and the
appliance no longer
applies water to the
floor because the
mopping brushes do
not rotate and the
appliance does not
mop up anything.
I cannot close the The mopping brush
mopping nozzle cover is not present
lid. or is not placed
properly.
The appliance You have moved the
leaves water appliance sideways.
traces on the
floor.
You have moved the
appliance across a
threshold while it was
switched on.
You have moved the
appliance with its
nozzle touching the
floor while it was
switched off.
You lifted the
appliance up from
the floor immediately
after you switched
it off.
The wheels are
blocked.
solution
Make sure the mopping brushes and the mopping brush
cover are assembled correctly. Close the mopping nozzle
lid properly. Make sure you press the lid until it locks with
a click (see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
Place the mopping brush cover into the mopping nozzle
properly and then close the mopping nozzle lid (see
chapter 'Cleaning and maintenance', section 'Reassembling
the mopping nozzle').
Only move the appliance forwards and backwards (see
chapter 'Using your Aqua Trio', section 'Cleaning tips').
Make sure the mopping brushes stay in contact with the
floor. Switch off the appliance before you pull it over a
threshold to prevent water traces on the floor or to
prevent water from splashing from the mopping nozzle
(see chapter 'Using your Aqua Trio', section 'Cleaning
tips').
If you want to avoid water traces on the floor, move the
appliance by carrying it by its carrying handle or by tilting
it so that it rests on its wheels for easy transport (see
chapter 'storing and moving your AquaTrio').
After you switch off the appliance, move it forwards
and backwards a few times to remove the liquid that is
present between the two mopping brushes. If you switch
off the appliance and lift it up immediately afterwards, the
water that was present between the brushes leaves a
trace of water on the floor.
Check the condition of the wheels. Remove the dirt that
blocks the wheels.
23