Installation Of Wall Bracket Covers - CHIEF WM210S Installation Instructions Manual

Installation Instructions
• Routing Cables from Above (Step 7)
7. Thread cables down through a surface mount cable
accessory (not included), then behind and into the wall
bracket. (See Figure 57) Proceed to Step 8
(view from front)
7
Figure 57
8. Route cables through cover mount, projector arm tunnel
and into projector. (See Figure 58)
Figure 58
Cables
Surface Mount
Cable Accessory
(not included)
Cables
7
(view from back)
Cables (example)
Cable clips
9. (Optional) Cables can be tied to inside of mount's front
cover using cable ties (not included). Route cables near
front cover and wrap cable tie through slots on front cover
and around cables. (See Figure 59)
Route through slots and
9
around cables
Figure 59
10. Replace removed cable management covers (if necessary).
Insert one side of cover into groove and press firmly on the
cover on the other side until it snaps into the other groove.
(See Figure 60)
10
Figure 60
11. Return outer covers to the mount following instructions in
Installing Mount Covers section.

Installation of Wall Bracket Covers

NOTE:
If security screws are going to be used, use the security
screws (V) to install wall bracket covers. See Security
Screw Installation section for details.
Cable tie (not included)
23