Installation (All Models); Mounting Wall Bracket - CHIEF WM210S Installation Instructions Manual

INSTALLATION - (All Models)
The WM2XXS/SI/AUS/AUSI short throw projector mounts can
be mounted to concrete, concrete block, wood studs or steel
studs. They can be mounted to 2" x 4" wood studs 16" apart.
WARNING:
ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires and cables before cutting, drilling, or
installing fasteners.
WARNING:
EXPLOSION AND FIRE HAZARD! CUTTING
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH
OR SERIOUS PERSONAL INJURY! ALWAYS make certain
area behind mounting surface is free of gas, water, waste, or
any other plumbing before cutting, drilling, or installing
fasteners.

Mounting Wall Bracket

Concrete or Concrete Block
1. Determine mounting location on wall.
2. Using wall bracket (B) as a template, mark four holes at the
holes in bracket. (See Figure 4)
3. Drill four 3/8" holes at marked locations in wall. (See Figure 4)
(front view)
2
3
(B)
Figure 4
4. Install four concrete anchors (K) into drilled holes. (See
Figure 5)
5. Install four 5/16 x 2-1/2" hex head lag screws (L) through
four 5/16" washers (M), outer holes of wall bracket (B) and
into concrete anchors (K). (See Figure 5)
10
x 4
x 4
5 (L) x 4
(M) x 4
(B)
Figure 5
Wood Studs
WARNING:
The wall to which the mount is being attached
may have a maximum drywall thickness of 5/8" (1.6cm).
1. Determine mounting location on wall. Use a stud finder to
locate 2" x 4" wood studs.
2. Line up inner four holes on wall bracket (B) with center of
studs at desired mounting location. (See Figure 6)
3. Using wall bracket (B) as a template, mark four holes at the
holes in bracket. (See Figure 6)
4. Drill four 7/32" holes at marked locations in wall. (See
Figure 6)
(front view)
(B)
3
4
Figure 6
Installation Instructions
4 (K) x 4
Wood studs
x 4
x 4