Cable Management (Optional); Removing Mount Covers - CHIEF WM210S Installation Instructions Manual

Installation Instructions
4. Lower the upper cover (X) onto the wall mount and lower
cover, and fasten with two 8-32 x 3/8" Phillips pan head
screws (AB). (See Figure 24)
NOTE:
Be sure cables and cords are not pinched between
upper and lower covers.
(AB) x 2
4
Figure 24

Cable Management (Optional)

In most cases, cable management covers will NOT need to be
removed in order to route cables from projector to the wall
mount. But for some thick cables, removing the covers may be
necessary.

Removing Mount Covers

1. Remove and save two 8-32 x 3/8" Phillips pan head screws
(AB) from upper cover. (See Figure 25)
2. Raise and remove the upper cover from the mount. (See
Figure 25)
2
1
Figure 25
(X)
Upper
cover
(AB) x 2
3. Remove and save two 8-32 x 3/8" Phillips pan head screws
(AB) from lower cover. (See Figure 26)
Lower
cover
Figure 26
4. Remove the lower cover from the wall mount. (See Figure 26)
5. Remove cable management covers (if necessary) from
short throw projector arm. (See Figure 27)
5
Cable
management
covers
Figure 27
(AB) x 2
3
4
(bottom view)
5
15