Wm2Xxsi/Wm2Xxausi Interactive Mount; Installing Mount Covers - CHIEF WM210S Installation Instructions Manual

UL Listed RPA Installation
1. Line up mounting holes on RPA mount with corresponding
holes on projector mounting plate. (See Figure 17)
2. Install four 1/4-20 x 3/8" Phillips pan machine screws (G)
through RPA holes and into projector mounting plate. (See
Figure 20)
Figure 20
3. Install interface and projector to RPA according to RPA and
interface bracket installation instructions.
UL Listed RSA Installation
1. Line up mounting holes on RSA mount with corresponding
holes on projector mounting plate. (See Figure 17)
2. Install four #10-24 x 3/8" Phillips pan machine screws (S)
through RSA holes and into projector mounting plate. (See
Figure 21)
Figure 21
3. Install interface and projector to RSA according to RSA and
interface bracket installation instructions.
14
Mounting plate
RPA
(G) x 4
2
Mounting plate
RSA
2
(S) x 4
IMPORTANT ! : Complete the installation by
proceeding to WM2XXSI/WM2XXAUSI Interactive
Mount section or WM2XXS/WM2XXAUS Standard
Mount section, as appropriate.
WM2XXSI/WM2XXAUSI INTERACTIVE
MOUNTS

Installing Mount Covers

1. Route cables from projector through cartridge in interactive
cover (Y). (See Figure 22)
Route cables
1
Cartridge
(Y)
Figure 22
2. Connect USB cable (AH) to cartridge through bottom of
lower cover.
3. Raise the lower cover containing cartridge and attach to
wall mount using two 8-32 x 3/8" Phillips pan head screws
(AB). (See Figure 23)
(Y)
Figure 23
Installation Instructions
Cartridge
(AB) x 2
3
3