CHIEF SMART-LIFT SL236 Installation Instructions Manual

CHIEF SMART-LIFT SL236 Installation Instructions Manual

Electric ceiling lift
Hide thumbs Also See for SMART-LIFT SL236:

Advertisement

I N S T A L L A T I O N I N S T R U C T I O N S
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio or television
communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit other than that to which the receiver is connected
Consult the dealer or and experienced radio/TV technician for help
SMART-LIFT™ Electric Ceiling Lift
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
SL236

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMART-LIFT SL236 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for CHIEF SMART-LIFT SL236

  • Page 1 I N S T A L L A T I O N I N S T R U C T I O N S Instrucciones de instalación Istruzioni di installazione Installationsanleitung Installatie-instructies Instruções de Instalação Instructions d´installation SMART-LIFT™ Electric Ceiling Lift This device complies with part 15 of the FCC rules.
  • Page 2: Important Safety Instructions

    Chief® is a registered trademark of Milestone AV Technologies. • Keep the test power cord away from heated surfaces.
  • Page 3: Installation Instructions

    Installation Instructions SL236 TOOLS REQUIRED FOR INSTALLATION PARTS A (1) [Ceiling Lift] (SL236FD Shown) B (1) [Push Button Assembly] D (1) [External Terminal C (5) Cover Plate] [Cable Tie] E (1) [Jumper Wire] F (5) [Cable Tie G (4) Mount] 6-32 x 3/16 H (2) [Rubber Grommet]...
  • Page 4 SL236 Installation Instructions LEGEND Pencil Mark Tighten Fastener Marcar con lápiz Apretar elemento de fijación Stiftmarkierung Befestigungsteil festziehen Marcar com lápis Apertar fixador Segno a matita Serrare il fissaggio Potloodmerkteken Bevestiging vastdraaien Marquage au crayon Serrez les fixations Drill Hole Loosen Fastener Perforar Aflojar elemento de fijación...
  • Page 5 Installation Instructions SL236 DIMENSIONS SL-236FD SL-236SP...
  • Page 6: Installation Requirements

    Test Cord Carefully inspect the SL236 for any shipping damage. If any damage is apparent, do NOT continue with the installation. Instead, contact Chief for further instructions. Attach supports (not provided) to the top of lift. (See Figure 1) Supports...
  • Page 7: Power Requirements And Wiring

    Installation Instructions SL236 WARNING: IMPROPER INSTALLATION CAN LEAD TO LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installers responsibility to make certain the structure to which the lift is being mounted is capable of supporting five times the weight of the lift and all attached equipment.
  • Page 8 SL236 Installation Instructions NOTE: The side channel of the lift will support the weight of the grid and ceiling tiles. Side Channel Closure Panel Figure 8 14. Install ceiling tile and grid by sliding it into the open end of the ceiling tile retainer.
  • Page 9: Installing In A Wood Framework (Joists)

    Installation Instructions SL236 Installing in a Wood Framework (Joists) Use 1/4" x 1" (minimum) Grade 2 lag screws (not provided) Yaw Adjustment to secure SL236 to the joists or wood framework, using the mounting tabs located on the sides of the SL236 housing. Bracket (See Figure 10).
  • Page 10 SL236 Installation Instructions Adjustments FORWARD/BACKWARD and PITCH • To shift projector backward or forward (or up or down), TRAVEL (SHOW ADJUSTMENT) loosen the nuts on each end of the yaw adjustment bracket. (See Figure 14) • Move mounting bracket forward or backward (or up or CAUTION: Do not overadjust (exceed maximum) travel down) as required.
  • Page 11: Connecting Control Wiring

    Installation Instructions SL236 ROLL (Horizontal Tilt) Connecting Control Wiring • Shift bracket up or down in the side holes on one side or the other by loosening nuts. • Adjust and tighten nuts on bracket. (See Figure 16) WARNING: All wiring should be performed by a licensed electrician following all local codes and ordinances.
  • Page 12: Connecting To Power Supply

    SL236 Installation Instructions Connecting to Power Supply IMPORTANT ! : This product must be connected to a grounded metal, permanent wiring system, or an equipment- grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the product.
  • Page 13 Installation Instructions SL236 Table 1: WIRING TABLE EXTERNAL WIRING INTERNAL WIRING Figure 18 NOTE: The numbers listed in the SL236 Internal and SL236 External columns refer to the corresponding numbers located where indicated in the wiring pictures. (See Figure 18)
  • Page 14 SL236 Installation Instructions Table 2: TERMINAL DESCRIPTIONS...
  • Page 15 Installation Instructions SL236 Figure 19...
  • Page 16 A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands Chief Manufacturing, a products division P +31 (0)40 2668620 of Milestone AV Technologies F +31 (0)40 2668615 Asia Pacific A Office No.

Table of Contents