Connection To Peripheral Equipment; Connection To The Ad-8121B Printer; Connection To A Computer - A&D GP-61KS Instruction Manual

15. CONNECTION TO PERIPHERAL EQUIPMENT

15-1 Connection to the AD-8121B Printer

Set the following parameters to use the AD-8121B printer.
Function setting
dout prt 0-3
dout ap-p 0-2
dout ap-b 0-2
dout pU5e 0, 1
5if bp5 2
5if btpr 0
5if Crlf 0
5if Ct5 0
When "MODE 1" or "MODE 2" of the AD-8121B printer is used
dout 5-td 0
dout 5-id 0
dout at-f 0
5if type 0
When "MODE 3" of the AD-8121B printer is used.
dout 5-td 0-3
dout 5-id 0, 1
dout at-f 0, 1
5if type 1
When data is transmitted continuously.
When all memory data is transmitted at one time.
dout pU5e 1
Note
The printer performs as follows, depending on the data memory setting.
Setting
data 0
data 2
data 3
Refer to "10. ID NUMBER AND GLP REPORT" for a print sample.

15-2 Connection to a Computer

The GP series balance is of the DCE type (Data Communication Equipment), which can be
connected to a personal computer using the RS-232C interface.
Before connection, read the personal computer manual thoroughly.
Use a standard DCE cable for connection (cable type: straight-through).
When the personal computer type is a DOS/V with a 9-pin port, use a straight-through cable with
a 25-pin male connector and a 9-pin female connector.
Factory setting
Factory setting
Factory setting
Factory setting
Factory setting
Factory setting
Factory setting
Factory setting
Uses pause.
What is printed
The weighing data
The weighing data stored in memory
The calibration or calibration test data stored in memory
Description
Selects a print mode.
Selects the polarity for the auto print mode.
Selects the auto print difference.
Selects data output pause.
2400 bps
7 bits, Even parity check
CR, LF
CTS and RTS control, not used
Not to output the time and date.
Not to output the ID number.
Not to use auto feed.
A&D standard format
Outputs the time and date as necessary.
Outputs the ID number as necessary.
Uses auto feed as necessary.
DP format
79