Data Memory; Notes On Using Data Memory - A&D GP-61KS Instruction Manual

Data memory is a function to store weighing data, calibration data and unit mass in memory. Of the
data in memory, the balance can only display the weighing data. The weighing data and calibration
data in memory are available for outputting at one time to a printer or personal computer.
One of the following data sets can be stored:
Weighing data (Up to 200 sets. 100 sets when the time and date are added.)
Calibration and calibration test data (latest 50 sets)
Unit mass in the counting mode (Up to 50 sets)
Comparator settings (the upper and lower limit values only, up to 20 sets)
Tare value (Up to 20 sets)

11-1 Notes on Using Data Memory

To use the memory function, set the "Data memory (data)" parameter of the function table. In
addition, for weighing data, set the "Time/Date output (5-td)" parameter. For details on setting the
data memory, refer to "9. FUNCTION TABLE".
For weighing data, the data contents to be stored and the storage capacity depend on the
"Time/Date output (5-td)" parameter setting.
Releasing "Clr"
If a different type of data exists in memory when the data is stored, "Clr" appears blinking in the
upper left of the display. For example, you want to store weighing data but calibration data or unit
mass data remains in memory.
Under such a condition, before storing data, delete the data in memory as follows:
1 Press and hold the PRINT key until SClr no
key.
2 Press the RE-ZERO key to display SClr go
The type of data stored in memory appears in the upper left of the display as shown below:
Unit mass in the counting mode
Weighing data without time and date
Weighing data with time and date
Calibration or calibration test data
Comparator settings
Tare value
3 Press the PRINT key to delete all the data in memory.
4 The balance displays

11. DATA MEMORY

end and returns to the weighing mode.
58
with "no" blinking is displayed, then release the
with "go" blinking.
pC
-d-
d-t
Hi5
Cp
tr