A&D AD-4408A Instruction Manual page 11

Key switches
No. Name
9 CAL
ON/OFF
10
ESC
11
ENTER
12
Net/B/G
13
NET GROSS
14
TARE
15 ZERO
16 Seal
• The key to enter the calibration mode.
• The key is concealed by a sealable cover.
To avoid unintentional operations, keep the cover attached
except when entering the calibration mode.
• The key to turn the indicator ON (Weighing mode) and OFF (OFF
mode).
• When OFF, all of the displays and external output/input devices
are turned OFF, but a decimal point located at the right side of
the main display remains ON.
• The key functions as an ESC key when the numerical values
are being entered.
• The key to proceed to the selected mode.
• Confirms the setting value and stores the data when pressed
after a setting is changed.
• The function for this key can be selected in the general
functions, from the list below:
No function
Manual print command
Hold
Alternate switch
Momentary switch
Clear the tare weight
Clear the zero value
• The key decreases the value of the blinking digit by one when
the numerical values are being entered.
• The key to switch between the gross weight and the net weight.
• The key increases the value of the blinking digit by one when
the numerical values are being entered.
• The key to perform tare.
• The tare conditions are set in the calibration-related functions.
• The key shifts the position of the blinking digit to the right when
the numerical values are being entered.
• In the OFF mode, pressing the ON/OFF key while holding the
TARE key will clear the zero value and the tare weight.
• The key to zero the current display.
• The zero conditions are set in the calibration-related functions.
• The key shifts the position of the blinking digit to the left when
the numerical values are being entered.
• Can be sealed using a wire seal.
Page 9
Description
AD-4408A