Base Holding; Intercom Mode; Searching For Handset/Base And Intercom; Transferring A Call - Siemens W10 User Manual

Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03
the user wants to operate in their internal system, then
he/she must change the pulse dialing to tone dialing
temporarily.
For example, you are required to enter your bank account
number:
1. Dial the bank's number.
2. Press * key when putting through.
3. Act according to the voice instructions over the
phone.
4. When finish, you can hang up the phone, and then
the phone returns to pulse dialing.

Base holding

Base -- call holding
Press the Hold key when talking to pause, and press again
to resume the call.

Intercom mode

Searching for handset / base and intercom
Base paging handset
Press the Intercom /Exit key on the base.
Press Talk key on the handset to stop the ring and start
talking to the base.
When finished, press the Hands-free/Dial back key on the
base or Talk key on the handset to terminate the call.
Handset paging base
Press Intercom /Exit key on the handset.
Press the Hands-free/Dial back key or pick up the handset
from the base to stop the ring and start talking by handset.
When finished, terminate the call by pressing the
Hands-free/Dial back key on the base, pressing the Talk
key on the handset, or placing the handset back to the base.
Note: When the handset and the base are being used
through intercom and a call comes in, both will stop and
ring.
Press either the Hands-free, the Talk key on the base, or the
handset to answer the call.

Transferring a call

Transferring a call from the base to the handset

When the user is answering a call using the base:
Press Intercom/Exit key on the base.
Dial handset code (1, 2, 3 or 4). The base will call the
14