Placing The Handset Into The Base Station And Charging The Batteries - Siemens Gigaset E 1 Manual

Preparing to use your phone
Placing the handset into the base station and
charging the batteries
When you place the handset into the E 150 base, the handset will
register automatically to the base. Do the following:
1. Place the handset with the screen facing up in the base
station.
2. Wait till the handset has registered automatically to the base.
The automatic registration takes around one minute. While
this is happening, Registration Procedure flashes in the
screen. After registration, the idle screen is displayed.
3. Now leave the handset in the charger for the batteries to
charge - the batteries are supplied uncharged. Battery charging
is indicated in the top right of the screen by the battery icon
flashing.
Should automatic registration be interrupted, register the
handset manually as described starting on page 9.
For the initial charge we recommend a continuous,
uninterrupted charging period of five hours, whatever
W
battery display is indicated. After a while the charge
capacity of the batteries will decrease for technical
reasons.
The battery charging status is correctly displayed only after
uninterrupted charging/discharging. You should therefore
avoid removing the batteries unnecessarily and ending the
charging process prematurely.
8