Table of Contents
Advertisement
STEP 1
At the Base Station:
1
Insert small plug on cord into phone
jack. Place cord in base cable
channel. Insert power supply unit
into wall outlet.
2
Insert plug on telephone cord into
telephone jack on base unit (clicks
into place). Place cord in cable
channel on bottom of base. Insert
other end of plug into telephone
jack on wall.
IMPORTANT: For best reception, place the base in a high central
location, away from other electrical devices. The installation of
the base unit should allow at least 8-inches between the base and
persons to be in compliance with FCC RF exposure guidelines.
STEP 2
IMPORTANT: Charge batteries 12 to 14 hours before using the
handset for the first time.
Customer Care: 1-888-777-0211 or visit our Website: www.my-siemens.com
Visite nuestro sitio Web para obtener instrucciones en español.
Base Station Setup
Handset Setup
At the Handset:
1
Remove protective plastic film from display.
2
Insert battery pack as shown.
3
Place battery cover on back of handset
and push gently upward until it clicks into
place.
4
Be sure power
supply is
plugged into
wall outlet.
Bottom view of base
110 VAC
60 HZ
Power
supply unit
and cord
Page/
Registration
button
Telephone
jack and
cord
Advertisement
Table of Contents
