Q&A - Siemens W10 User Manual

Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03
Q&A
Caller numbers
Question
No display
Show error about the caller's information
Calls
Question
No pulse or tone
dialing tone
Can't make
calls but the
keyboard
sounds normal
No ring
Dialed out call records (Dialing from CID)
- Did you enter the correct location code of the call record?
- Did you dial out the call record correctly?
- Be sure the settings of the tone and pulse dialing are correct.
- Did you re-save the records after replacing batteries?
Answer
Check the installation:
Did you plug the phone cord into the location marked with
"Phone Line" at the back of the base, then plug the other
end of the cord into the socket of the phone cord on the
wall?
Plug the phone cord out of the base, then plug it into
another phone set to see if the other phone meets the same
problem. If so, the problem is caused by phone line or
phone service.
Be sure the batteries are full.
Be sure the insertion of the batteries is correct.
Be sure that the settings of the tone and pulse dialing are
correct.
Be sure the ring is set On
Maybe you have equipped with too many extensions,
unplug some to see if the problem still exists.
Answer
Replace the batteries and be sure they are
inserted correctly.
Have you applied for the Incoming Call
Display service from your phone service
company?
If the base receives any information that is
different from the
information, it will show error.
valid incoming call
24