Table of Contents
Advertisement
Color Setting
Dimmer Curves
Control Panel
Lock
Color Macro
Adjustment
Page 14 of 28
Continued from previous page
The COLOR setting determines how the WELL generates the white color based on various
RGB settings.
1) Go to SET.
2) Select COLO.
3) Select OFF, RGBW, or UC.
OFF: When the RGB faders are all set to "255", the output is maximum,
although the resulting white color may not be balanced.
RGBW: When the RGB faders are all set to "255", the resulting output is defined by
the configured White color (see
UC: When the RGB faders are all set to "255", the output matches that of less
efficient fixtures (Universal Color).
This setting determines how fast the output of the WELL changes when the operator
modifies the values of the Red, Green, Blue, and Dimmer faders.
1) Go to SET.
2) Select DIM.
3) Select a dimmer curve (OFF, DIM1, DIM2, DIM3, or DIM4).
OFF: The output is proportional (linear) to the Dimmer and RGB channel values.
DIM1~4: The output follows the Dimmer and RGB channel values based on the
corresponding dimmer curve, being DIM1 the fastest and DIM4 the
slowest.
This setting allows the user to activate or disable the control panel lock, which keeps non-
authorized personnel from changing the fixture's settings.
1) Go to KEY.
2) Select ON or OFF.
When the control panel lock is active, the fixture will prompt the user to enter the
password after 30 seconds of control panel inactivity or after turning on the fixture.
After being prompted to enter the password:
Press <UP>, <DOWN>, <UP>, <DOWN>, and <ENTER>.
This setting allows the user to select and edit the temperature of the white colors used in
channel 8 (Macros) when in the TOUR mode.
1) Go to CAL1.
2) Select a white color (WH.01~11).
3) Select a color (RED, GREN, or BLUE).
4) Select a color value (0~255).
5) Repeat for the other colors.
Continues on the next page
RGB to White Adjustment
WELL™ 2.0 User Manual Rev. 01
).
Advertisement
Table of Contents
