Setup; Ac Power; Ac Plug; Fuse - Chauvet WELL User Manual

3. Setup

AC Power

AC Plug

Fuse

DMX Linking

DMX Modes

WELL™ 2.0 User Manual Rev. 01
The WELL's battery charger, whether stand-alone or inside the flight case, has an auto-
ranging power supply that can work with an input voltage range of 100~240 VAC,
50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this guide, the product's user manual, or on the product's sticker.
Always connect this product's battery charger to a protected circuit with an
appropriate electrical ground to avoid the risk of electrocution or fire.
Never connect this product's battery charger to a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer channel serves only as a
0 to 100% switch.
The WELL's battery charger comes with a power input cord terminated with an Edison plug
(US market). If the power input cord that came with your product has no plug or you need
to change the Edison plug, use the table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
Make sure to disconnect the fixture's power cord before replacing a blown fuse, and
always replace it with a fuse of the same type and rating.
The stand-alone battery charger has no external fuse. However, the
flight case/charger comes with a replaceable fuse (T 6.3 A @ 250 V).
To change the fuse on the flight case/charger, do the following:
1) Disconnect the fixture from the power outlet.
2) With a Phillips #2 head screwdriver, unscrew the fuse holder cap
from its housing.
3) Remove the blown fuse and replace it with a good fuse of the
same type and rating (T 6.3 A @ 250 V).
4) Screw the fuse holder cap back in its place and reconnect power.
You may link the WELL™ 2.0 to a DMX controller using a standard DMX serial connection.
If using other DMX compatible fixtures with this product, it is possible to control them
individually with a single DMX controller.
If you are not familiar with the DMX standard, or if you need information about the DMX
cables needed to link the WELL™ 2.0 to a DMX controller, you may download the "DMX
Primer" document from the CHAUVET® Web site.
The WELL™ 2.0 uses the standard DMX data connection for its TOUR, ARC.1, AR1.D,
AR1.S, HSV, and BLOC DMX modes. You will find information about these DMX modes in
the Introduction chapter (DMX channel summary), the Operation chapter (configuration
details), and the DMX Values section (individual channel values).
Wire (US) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
Screw Color
Brown Yellow/Brass
Blue Silver
Green
Page 7 of 28