Table of Contents
Advertisement
4. Operation
Operation
Notes
Turning Unit On
Turning Unit Off
Tilt Angle
LEDs Angle
Password
Storage Notes
WELL™ 2.0 User Manual Rev. 01
· Always operate the unit in an upright position.
· Never tilt the unit more than 10º.
· Only use the retractable foot to tilt the unit.
· Do not operate the unit in a sealed enclosure or in an area without air circulation.
· Turn the battery storage switch on.
· Push the On/Off switch on the top for more than three seconds (the built-in red LED
will illuminate solid).
· When not connected to the battery charger, the power status LED indicates the
amount of remaining battery charge, as follows:
Green:
>70 % (100~70% charge)
Yellow:
>20 % (69~21 % charge)
Red:
Empty (20~0 % charge)
· Push the On/Off switch on the top for more than three seconds (the built-in red LED
will turn off).
· If storing the unit for more than seven days after recharging it, also turn the battery
storage switch off.
· Place the fixture on a flat, sturdy surface.
· Release the extensible foot by shifting the foot release lever.
· Keep the lever shifted to adjust the angle and release the lever.
· Do not allow the unit to tilt further than 10º.
· Use the screws on the unit's front panel to adjust the angle of the LED panels.
· The screw on the left adjusts the rear LED panel.
· The screw on the right adjusts the front LED panel.
After being prompted, enter the following password by pressing:
<UP>, <DOWN>< <UP>, <DOWN>, <ENTER>
The password cannot be changed and must be used when prompted.
· Always store the unit in an upright position (≤ 10º tilt).
· Recharge the battery to full capacity before storing the unit.
· Store charged unit(s) in a dry environment, away from direct sunlight.
· Turn the battery storage switch off if storing the unit for more than seven days.
Page 9 of 28
Advertisement
Table of Contents
