Recording; Recording The Input Source; Recording From Different Av Sources - Integra DTR-4.9 Instruction Manual

Recording

This section explains how to record the input source and
how to record audio and video from separate sources.
Notes:
• The surround sound and DSP listening modes cannot
be recorded.
• Copy-protected DVDs cannot be recorded.
• Sources connected to the analog multichannel input
cannot be recorded.
• Sources connected to a digital input cannot be
recorded. Only analog inputs can be recorded.
• DTS signals will be recorded as noise, so don't
attempt analog recording of DTS CDs or LDs.

Recording the Input Source

Audio sources can be recorded to a recorder (e.g., cas-
sette deck, CDR, MD) connected to the TAPE OUT jack.
Video sources can be recorded to a video recorder (e.g.,
VCR, DVR) connected to the VCR/DVR OUT jacks.
See pages 19 to 33 for hookup information.
1 Use the input selector buttons to
select the source that you want
to record.
See "Which Connections Should I
Use?" on page 20 to see which signals
can be output and recorded.
You can watch the source while record-
ing it. The AV receiver's Master Vol-
Remote
controller ume control has no effect on recording.
2
On your recorder, start record-
ing.
3 On the source component, start
playback.
Note:
• If you select a different input source during recording,
that input source will be recorded instead.
56

Recording from Different AV Sources

You can overdub audio onto your video recordings by
simultaneously recording audio and video from two sep-
arate sources. This is possible because only the audio
source is switched when an audio-only input source,
such as TAPE, TUNER, or CD, is selected, the video
source remains the same.
In the following example, audio from the CD player con-
nected to the CD IN and video from the camcorder con-
nected to the GAME/TV V jack are recorded by the VCR
connected to the VCR/DVR OUT jacks.
video signal
audio signal
CD player
1 Prepare the camcorder and CD player for
playback.
2
Prepare the VCR for recording.
3
Press the [Game/TV] input selector but-
ton.
4
Press the [CD] input selector button.
This selects the CD player as the audio source but
leaves the camcorder as the video source.
5
Start recording on the VCR, then start
playback on the camcorder and CD player.
Video from the camcorder and audio from the CD
player are recorded by the VCR.
Camcorder
AM
ANTENNA
FM
75
VCR