Advanced Setup; Source Setup - Integra DTR-4.9 Instruction Manual

Advanced Setup

Source Setup

This section explains items on the Source Setup menu.
Items can be set individually for each input selector.
1
Press the input selector buttons
to select an input source, and
then press the [Receiver] Remote
Mode button.
2
Press the [Setup] button.
3
Use the Up and Down [ ]/[ ]
buttons to select "4. Source
Setup," and then press [Enter].
4
Use the Up and Down [ ]/[ ]
buttons to select an item, and
then press [Enter].
5 Use the Left and Right [
buttons to change it.
The Source Setup menu items are
explained below.
6
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
IntelliVol
With IntelliVolume, you can set the input level for each
input selector individually. This is useful if one of your
source components is louder or quieter than the others.
Use the Left and Right [
If a component is noticeably louder than the others, use
the Left [ ] button to reduce its input level. If it's
noticeably quieter, use the Right [
its input level. The input level can be adjusted from
–12 dB to +12 dB in 1 dB steps.
Note:
• IntelliVolume does not apply for Zone 2.
A/V Sync
When using your DVD player's progressive scanning
function, you may find that the picture and sound are out
of sync. With the A/V Sync setting, you can correct this
by applying a delay to the audio signal. The delay can be
set from 0 to 100 milliseconds (msec) in 5 millisecond
steps.
Use the Up and Down [
input selector, and use the Left and Right [
tons to set the delay.
To view the TV picture while setting the delay, press
[Enter].
If HDMI Lip Sync is enabled (see page 64), and your TV
or display supports HDMI Lip Sync, the displayed delay
time will be the A/V Sync delay time. The HDMI Lip
Sync delay time is displayed underneath in parentheses.
Note:
• A/V Sync is disabled when the Direct listening mode
is used with an analog input source.
]/[ ]
When you've finished, press the
[Setup] button.
Setup closes.
]/[ ] buttons to set the level.
] button to increase
]/[ ] buttons to select an
]/[ ] but-
61